Manual offset does not take effect in the ZDC unit of Olympus?

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|

Manual offset does not take effect in the ZDC unit of Olympus?

hchenuci
Dear Friends,

I am using Olympus IX81 with ZDC unit.
I can use the " MeasureOffset " and find the ZDC offset and it works.
but when I tried to manually put a number in the offset section in the
uManager,
With autofocus activated, it will still use the offset measured by "
MeasureOffset " earlier,
regardless the number in the offset section.

Is there anything I am missing?

Thanks.

Best Regards,
Hongtao Chen





--
Sent from: http://micro-manager.3463995.n2.nabble.com/

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
micro-manager-general mailing list
[hidden email]
https://lists.sourceforge.net/lists/listinfo/micro-manager-general